Specialist Modules

Advantech ADAM-5000 frequency modules and counter modules, such as the ADAM-5080 and ADAM-5081, can be remotely configured to up / down, bi-directional, counter, frequency, and alarm setting modes. ADAM-5080 is a 4-Channel Frequency/Counter Module and ADAM-5081 is a 4-Channel High Speed Frequency/Counter Module.

2-slot SD Storage Module

• Storage Type: SD (Secure Digital Card)
• ストレージタイプ: SDカード
• USB Type: USB Rev 2.0 (Compliant)
• USB Number: 2, SD Card Number: 2
• Max Storage: 1GB x 2
• Interface: PCI Bus
• Format: FAT-16
• Operating Temperature: 0 ~ 60° C (32 ~ 140° F)

ADAM-5030 is a 2-slot secure digital card storage module that provides 2 USB ports and 2 SD slots. It is fully compliant with USB 2.0 and FAT16 and is also low power consuming, at only 0.5W. According the volume of SD Card, you can extend the memory of your controller up 2 GB. Unlike commercial modules, it is very rugged, and has a very long lifecycle.

2-port AMONet Master Module

• Communication Slave: 2 Rings with Max. 128 (1 Ring with 64 slaves) Module Number
• Communication: Max. 100 m (20 Mbps/32 slave modules) or 50 m (20 Mbps/64 slave modules) Distance
• Serial Interface: Half duplex RS-485 with transformer isolation
• Surge Protection: 10 kV
• Transmission Speed: 2.5, 5, 10 or 20 Mbps with automatic data flow control
• Remote motion and remote IO function
• LED Indictors: Active, Error (Each Port)
• Operating Temperature: 0 ~ 50° C (32 ~ 140° F)

ADAM-5202 is a 2-ring AMONet module that provides 128 maximum slaves and supports 100-meter long distance communications. The transmission speed can support 2.5, 5, 10 or 20 Mbps with automatic data flow control. It accepts half duplex RS-485 serial interfaces with transformer isolation. This module can also function as a motion module for AMONet Master Control.

4-axis Stepping/Pulse-type Servo Motor Control Module

• High-speed 4-axis stepping/pulse-type servo motion control
• Hand wheel and jog function
• 2/3-axis linear interpolation function
• 2-axis circular interpolation function
• Continuous interpolation function
• Programmable T/S-curve acceleration/deceleration rate
• Up to 4 MPPS output for each axis
• Two pulse output types: CW/CCW or Pulse/Direction
• Up to 1 MHz encoder input for each axis
• Two encoder pulse input types: A/B phase or Up/Down
• Position management and software limit switch function

Advantech's Industrial Automation Group introduces the ADAM-5240, a 4-axis Stepping/Pulse-type Servo Motor Control Module for use with ADAM-5550 Series PACs (Programmable Automation Controllers). ADAM-5240 is is fully integrated to fulfill general purpose motion applications. Equipped with high speed 4-axis motion control module that simplifies stepping and pulse-type servo motor control, ADAM-5240 provides advanced performance.